This fixes an issue where the udp port was not being opened due to a
permission denied error. The result of this was the dhcp client would
fail to send the renewal request and so the dhcp lease would expire.
The addition of the CAP_NET_BIND_SERVICE capability allows the service
to open sockets in the restricted port range (<1024) which is required
for dhcp.
This is based on a previous patch by Roberto Santalla Fernández.
A new config is introduced into the network config file under IPv4
called SendHostname. If this is set to true then we add the hostname
into all DHCP requests. The default is false.
If the idea is that the interface should only be present when connected
then don't do this in the DISCONNECTING state as there are various
possible transitions from CONNECTED or ROAMING directly to DISCONNECTED.
The Changed() method did not actually return anything, and in fact the
no_reply flag for that message was set.
Similarly, the Release method does not expect a reply.
Don't require a gateway address from the settings file or from the DHCP
server when doing netconfig. Failing when the gateway address was
missing was breaking P2P but also small local networks.
Be paranoid and check that the prefix length in addresses from
used_addr4_list are not zero (they shouldn't be) and that address family
is AF_INET (it should be), mainly to quiet coverity warnings:
While there also fix one line's indentation.
At the end of ip_pool_select_addr4() we'd check if the selected address
is equal to the subnet address and increment it by 1 to produce a valid
host address for the AP. That check was always correct only with 24-bit
prefix, extend it to actually use the prefix-dependent mask instead of
0xff. Fixes a testAP failure triggered 50% of the times because the
netmask is 28 bit long there.
Don't signal the connected state until the client has obtained a DHCP
lease and we can set the ConnectedIP property. From now on that
property is always set when there's a connection.
p2p_parse_association_req() already extracts the P2P IE payload from the
IE sequence, there's no need to call ie_tlv_extract_p2p_payload before
it. Pass the IE sequence directly to p2p_parse_association_req().
Similarly to commit
27d302a0 ("band: Add a utility to estimate VHT rx data rate"), this
commit adds an RX data rate estimation utility for HT connections.
