Similarly to l_netconfig track whether IWD's netconfig is active (from
the moment of netconfig_configure() till netconfig_reset()) using a
"started" flag and avoid handling or emitting any events after "started"
is cleared.
This fixes an occasional issue with the Netconfig Agent backend where
station would reset netconfig, netconfig would issue DBus calls to clear
addresses and routes, station would go into DISCONNECTING, perhaps
finish and go into DISCONNECTED and after a while the DBus calls would
come back with an error which would cause a NETCONFIG_EVENT_FAILED
causing station to call netdev_disconnct() for a second time and
transition to and get stuck in DISCONNECTING.
Add a second netconfig-commit backend which, if enabled, doesn't
directly send any of the network configuration to the kernel or system
files but delegates the operation to an interested client's D-Bus
method as described in doc/agent-api.txt. This backend is switched to
when a client registers a netconfig agent object and is swiched away
from when the client disconnects or unregisters the agent. Only one
netconfig agent can be registered any given time.
Add netconfig_event_handler() that responds to events emitted by
the l_netconfig object by calling netconfig_commit, tracking whether
we're connected for either address family and emitting
NETCONFIG_EVENT_CONNECTED or NETCONFIG_EVENT_FAILED as necessary.
NETCONFIG_EVENT_FAILED is a new event as until now failures would cause
the netconfig state machine to stop but no event emitted so that
station.c could take action. As before, these events are only
emitted based on the IPv4 configuration state, not IPv6.
Add netconfig-commit.c whose main method, netconfig_commit actually sets
the configuration obtained by l_netconfig to the system netdev,
specifically it sets local addresses on the interface, adds routes to the
routing table, sets DNS related data and may add entries to the neighbor
cache. netconfig-commit.c uses a backend-ops type structure to allow
for switching backends. In this commit there's only a default backend
that uses l_netconfig_rtnl_apply() and a struct resolve object to write
the configuration.
netconfig_gateway_to_arp is moved from netconfig.c to netconfig-commit.c
(and renamed.) The struct netconfig definition is moved to netconfig.h
so that both files can access the settings stored in the struct.
Andrew Zaborowski