iwd/autotests/testSAQuery-spoofing/ssidCCMP.conf

hw_mode=g
channel=1
ssid=ssidCCMP

wpa=2
wpa_pairwise=CCMP
wpa_passphrase=secret123

ieee80211w=2
wpa_key_mgmt=WPA-PSK-SHA256
beacon_int=10
auto-t: add SA Query tests Two autotests: 1. Tests SA Query procedure when the AP goes down. In this case the AP goes down ungracefully, now allowing it to send out any deauth frames. When the AP comes back up, IWD still thinks its connected. The AP will then send unprotected disassociate frames so the client can re-connect. This kicks off the SA Query procedure, which the AP will not respond to. At this point we can deauth and reconnect to the AP. 2. Test SA Query procedure when a disassociate frame has been spoofed. In this case we receive an unprotected disassociate frame and start SA Query. The AP should then respond to the SA query within the timeout. We then know the frame was spoofed and can remain connected. 2018-01-31 09:56:00 -08:00			`hw_mode=g`
			`channel=1`
			`ssid=ssidCCMP`

			`wpa=2`
			`wpa_pairwise=CCMP`
			`wpa_passphrase=secret123`

			`ieee80211w=2`
			`wpa_key_mgmt=WPA-PSK-SHA256`
auto-t: make hwsim registration off by default With the addition of connect_bssid/roam very few tests actually require hwsim. Since hwsim can lead to problems with scan results its best to have it off by default and have each test that needs it explicitly turn it on. Tests which previously turned it off have had that option removed. Tests that do require hwsim still are vulnerable to scan result problems, so for these tests beacon_int was added to the hostapd config which seems to help with reliability somewhat. 2021-08-12 13:38:10 -07:00			`beacon_int=10`