iwd/autotests/testPSK-roam/hw.conf

[SETUP]
num_radios=3
start_iwd=0
hwsim_medium=yes

[HOSTAPD]
rad0=ft-psk-ccmp-1.conf
rad1=ft-psk-ccmp-2.conf
auto-t: add test for FT-over-DS 2019-05-09 20:16:29 +02:00			`[SETUP]`
			`num_radios=3`
auto-t: Change FT test cases to use start_iwd=0 These test cases depend on setting up the existing hostapd instance to a set of known addresses, which might be different from what test-runner sets. During this time, any scans might result in the old and the new addresses used by hostapd to be found in the scan results. Fix that by using start_iwd=0 which tells test_runner that the test wants to start iwd itself. This delays starting iwd until after the setUpClass routine has been called and hostapd configured properly. Also use more sensible rssi values for the 'non-preferred' bss. Otherwise, ranking BSSes by throughput can confuse the test logic since both BSSes are ranked the same and either can be picked by autoconnect. 2021-05-21 18:44:55 +02:00			`start_iwd=0`
auto-t: make hwsim registration off by default With the addition of connect_bssid/roam very few tests actually require hwsim. Since hwsim can lead to problems with scan results its best to have it off by default and have each test that needs it explicitly turn it on. Tests which previously turned it off have had that option removed. Tests that do require hwsim still are vulnerable to scan result problems, so for these tests beacon_int was added to the hostapd config which seems to help with reliability somewhat. 2021-08-12 22:38:10 +02:00			`hwsim_medium=yes`
auto-t: add test for FT-over-DS 2019-05-09 20:16:29 +02:00
			`[HOSTAPD]`
			`rad0=ft-psk-ccmp-1.conf`
			`rad1=ft-psk-ccmp-2.conf`